![]() ![]() Neighbor ID Pri State Dead Time Interface ID InterfaceĢ.2.2.2 1 FULL/DR 00:00:39 2 FastEthernet0/0 OSPFv3 1 address-family ipv4 (router-id 1.1.1.1) Verify OSPFv3 adjacency, R2 is the DR because the highest router-id: Inside the Network LSA Type 2 generated by a DR, there is no information of the subnet mask and the DR address, only the attached routers are carried.Ĭonfigure R1 and R2 using OSPFv3 Address Family, R3 will be configured later With OSPFv3 the LSA Type 2 does not carry the used subnet mask and the DR address. ![]() This information is used by each router participating in OSPF to build the exact picture of the described multiaccess segment, which cannot be fully described with just LSAs Type 1. By definition with OSPFv2 the content of the LSA Type 2 describes the network segment listing the DR address, the attached routers, and the used subnet mask.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |